Kyocera FS-3040MFP+ - Page 181

2MF/2MG
1-5-40
12. Remove seven screws-A and drum
grounding plate and two grounding ter-
minals.
13. Remove the AC inlet.
Figure 1-5-60
14. Remove two screws and two grounding
terminals.
15. Remove one connector.
16. Remove the PWB connector between
connect-L PWB and power source unit.
17. Remove the power source unit.
Figure 1-5-61
Screw
Screw
(M3)
Grounding
terminal
AC inlet
Drum
grounding
plate
Screw
Screw
Screw
(M3)
Screw
Screw
(M3)
Grounding
terminal
PWB connector
Connect-L PWB
Connector
Power source unit
Screws
Grounding
terminals