DZP
87
DZP — Draw to Zero-relative Position
Format
DZP x-coordinate, y-coordinate;
Parameters
x-coordinate:
distance from the left edge limit of paper
y-coordinate:
distance from the top edge limit of paper
Function
The DZP command draws a line from the current cursor position to a position specified
relative to the top and left edge limits of the paper.
The thickness of the line is designated by the SPD (set pen diameter) command. The
coordinates and line thickness are measured in the value designated by the UNIT
command. The coordinates should be positive or zero. Negative coordinates are treated
as zero.
The DZP command is ignored within a path construction. To add a zero-relative line
segment in a path, use the PDZP (in Path, Draw to Zero-relative Position) command.
File
!R! RES;UNIT C;
MZP 0, 0; DZP 0, 5;
MZP 1, 0; DZP 0, 4;
MZP 2, 0; DZP 0, 3;
MZP 3, 0; DZP 0, 2;
MZP 4, 0; DZP 0, 1;
MZP 5, 0; DZP 0, 0;
PAGE;
EXIT;
To Next Page
Loading...
Need help?
General
