4-12
4. Selecting the Printer Settings
Item
1 Selecting the font
Selects the font that will be used for printing. This setting
is made by entering the ID of the desired font. To select a
font that is already installed in the printer, enter “I###”
(with the desired font ID entered in place of ###). To verify
font IDs, print out a Font List by following the procedure in
“(18) Font List print out”. It is possible to select a font other
than those already installed, such as those contained in
the optional Memory Card.
Optional font IDs such as “S###”, etc., start with different
letters according to the type of the font as shown below.
S: Software font (download)
M: Memory card font
H: Hardware font
H: RAM disk font
O: Optional ROM font
2 Courier
Allows you to select between “Regular” and “Dark (bold)”.
3 Letter Gothic
Allows you to select between “Regular” and “Dark (bold)”.
4 Font List print out
Available settings
Regular
Dark
Regular
Dark
Remarks
The font can be set separately for
each interface. To select an installed
font, select “Internal”. To select a font
other than those already installed,
select “Option” and set the desired
font.
Displayed only when the “Internal” is
selected.
Displayed only when the “Internal” is
selected.
4-4 Font selection/settings
About the font selection/settings
It is possible to perform font selection/settings for the 4 items shown in the following chart.
For the most efficient use of the printer functions, select the various settings according to your printing needs.
To Next Page
Loading...
Need help?
General
