User Guide for the Kyocera Xcursion Phone 13
Setting roaming alerts and
ringers
Setting an alert for roaming
You may use this setting if you want the phone
to alert you when you roam outside of your home
service area.
1. Select Menu → Settings → Network →
Roam/Svc Alert.
2. Select an option and press .
–
When no svc alerts you with three tones
decreasing in pitch when service is lost and
three tones increasing in pitch when service
is acquired again.
–
On roam change alerts you with two
decreasing tones when roaming service is
acquired and three increasing tones when
home area service is acquired again.
–
On any change alerts you with three
increasing tones if there is a change in
roaming service or three decreasing tones
if the phone loses service.
Setting the roam ringer
You can set a ringer to indicate when an incoming
call is subject to roaming charges.
1. Select Menu → Settings → Sounds →
Roam Ringer.
2. Highlight Enabled to hear the ringer.
3. Press to set.
Setting Call Guard to avoid roming calls
You can set the phone to warn you before you
answer or place a call while roaming.
• Select
Menu → Settings → Convenience →
Call Guard → Call prompt.
– The phone now emits a distinctive roam
ring to indicate when you are roaming
during calls.
– To accept or place a call while roaming,
you must press .
Note: This functionality is disabled when the phone
is in emergency mode.
Controlling network roaming
Specifying digital or analog mode
Depending on services available from your service
provider, you may set the phone to either digital
or analog mode. This is useful if you are in an area
that borders on digital service and the automatic
feature is causing the phone to keep switching
between modes.
1. Select Menu → Settings → Network →
Digital/Analog.
2. Select an option and press .
–
Automatic automatically switches the phone
between digital and analog.
–
Analog only sets the phone to work in
analog mode only.
–
Analog call forces a call into analog mode
for the duration of the next call.
–
Digital only sets the phone to work in digital
mode only.