User Guide for the Kyocera Xcursion Phone 13
Timing your calls
You can set your phone to beep 10 seconds
before each minute passes when you are on a call.
•Select
Menu → Settings → Sounds →
Minute Alert → Enabled.
Receiving data or faxes
Your phone may be able to receive certain data
or faxes, depending on the system sending the
information. For more information, see page 41.
Setting roaming alerts
and ringers
Setting an alert for roaming
You may use this setting if you want the phone
to alert you when you roam outside of your home
service area.
1. Select Menu → Settings → Network →
Roam/Svc Alert.
2. Select an option and press .
–
When no svc alerts you with three tones
decreasing in pitch when service is lost
and three tones increasing in pitch when
service is acquired again.
–
On roam change alerts you with two
decreasing tones when roaming service is
acquired and three increasing tones when
home area service is acquired again.
–
On any change alerts you with three
increasing tones if there is a change in
roaming service or three decreasing tones
if the phone loses service.
Setting the roam ringer
You can set a ringer to indicate when an incoming
call is subject to roaming charges.
1. Select Menu → Settings → Sounds →
Roam Ringer.
2. Highlight Enabled to hear the ringer.
3. Press to set.
Setting Call Guard to avoid roming
calls
You can set the phone to warn you before you
answer or place a call while roaming.
•Select
Menu → Settings → Convenience →
Call Guard → Call prompt.
– The phone now emits a distinctive roam
ring to indicate when you are roaming
during calls.
– To accept or place a call while roaming,
you must press .
Note: This functionality is disabled when the
phone is in emergency mode.
82-N8671-1EN.book Page 13 Tuesday, October 4, 2005 3:49 PM
To Next Page
Loading...
Need help?
General
