Kzyee KM10 - 3.2 Continuity Testing

Vehicle Super Probe
- 9 -
3.2 Continuity Testing
While the tool is in Resistance mode, using the probe tip with chass is ground or the
auxiliary ground lead, continuity can be tested on wires and components attached or
disconnected from the vehicle’s electrical system.
When the probe tip is contacting a good ground, the LCD will indicate “0.0Ω” and
green LED will be on. A beep tone will sound (Figure 8).
Figure 8
In other cases, the LCD only indicates the resistance value. (Figure 9)
Figure 9
If the resistance value is greater than 100KΩ, the LCD will show “0L”.