Inspection and preventive maintenance
Moving parts
1. Press the push button. The ball-locking mechanism is retracted.
2. Release the button. The ball-locking mechanism is activated.
3. Insert the pin in each storage and rigging hole. Pull and rotate the pin.
The pin must remain inside the hole.
If the pin is inserted in two plates, the ball must pass through both plates and lock the pin in place.
If the check fails, immediately withdraw the product from use and contact L-Acoustics.
Repair kits (KR)
A15-BUMP KR PIN1394 (Kit 2 x pin 1394 )
A15-RIGBAR KR PIN1394 (Kit 2 x pin 1394 )
A-TILT G03461 (KR ball-locking pin A15-LIFT/A-TILT )
M-BAR KR PIN665 (Kit 10 pins 9.5mm diameter screws & rivets)
Related tasks
Rigging part inspection (p.29)
KS21 owner's manual (EN) version 2.1 37
To Next Page
Loading...
