Need help?Do you have a question about the L-Acoustics X12 and is the answer not in the manual?
General| Brand | L-Acoustics |
|---|---|
| Model | X12 |
| Category | Speaker System |
| Language | English |
Inspect system, perform preventive maintenance, use approved accessories, and avoid unstable storage.
Compliance with Machinery Directive; safety factors for flown deployments.
Model system in Soundvision, check Mechanical Data for stress/stability warnings.
Ground-stacked, flown array, and unusual condition safety considerations.
X12 with SB15m for augmented LF, reinforced contour, and pre-alignment delays.
X12 with SB18 for reinforced LF, extended bandwidth, and pre-alignment delays.
X12 with KS21 for reinforced LF, extended bandwidth, and pre-alignment delays.
X12 as a stage monitor with [X12_MO] preset and low-latency options.
X12 stage monitor with SB15m for augmented LF and pre-alignment delays.
X12 stage monitor with SB18 for augmented LF and pre-alignment delays.
X12 stage monitor with KS21 for augmented LF and pre-alignment delays.
List of procedures: system inspection, rigging/hardware check, and acoustics check.
Detailed procedure for inspecting rigging parts for wear, damage, and loose fasteners.
Highlights critical parts of lifting chains and indicates visual/functional checks.
Inspection points for X12 with X-UL12, X-US1215/X-UTILT rigging.
Inspection points for X12 with X-BAR/CLAMP250 and pole-mounted configurations.
Criteria for checking runners, risers, and threaded knobs.
Procedure for measuring loudspeaker impedance to detect circuit continuity issues.
Table for interpreting OK, ?, NC, NOK, UNDEF results and corresponding instructions.
Procedure for testing sound quality and troubleshooting LF speaker issues.
Diagnosing and resolving HF driver issues like distortion, vibrations, or weak sound.
Placing enclosure in U-bracket and locking knobs via spring-lock mechanism.
Adjusting site angle using the reference screw and tightening knobs for stability.
Attaching rigging arm to U-bracket, ensuring correct position and using central insert.
Ensuring connected enclosures do not exceed controller capacity (LA4X, LA8, LA12X).
Procedure for grill removal and reinstallation using specific tools and torque.
Procedure for replacing the coaxial speaker, including gasket and screws.
Procedure for HF diaphragm replacement, including cover removal and shim management.
Procedure for cleaning air gap, placing shims, diaphragm, and securing the cover.
Visual guide showing forbidden and authorized ways to mount the X12 enclosure.
Further visual examples of forbidden and authorized mounting configurations.
To Next Page
