TEMPERATURE & HUMIDITY ALERTS
To set alerts:
1. Hold the ALERTS button to enter alert set mode. Outdoor HI ALERT OFF will
show. To set this alert value, press and release the + or - button to arm this
alert (ON).
2. When the alert is armed (ON) the alert value will flash. Press and release the +
or - button to change alert values.
3. Press and release the ALERTS button to confirm and move to the next alert. If
you do not wish to set an alert, press the ALERTS button again to move the next
alert or to exit.
4. Press the SNOOZE/BACKLIGHT button at anytime to exit the Alerts Menu.
Active Alert:
• The Alert Icon will only show when the alert is active, and indicate the HI or LO
alert.
• When armed alert value is reached, station will beep 5 times, once each minute,
until out of alert range.
• The flashing alert icon will indicate whether it is a LO or HI alert.
• Press any button to stop the temp alert sound.
• The alert icon will still flash while value is in alert range.
Disarm Alert:
1. Hold the ALERTS button to enter alert setting menu.
2. Press the ALERTS button until you see the alert you wish to disarm.
3. Press and release the + or - button to disarm the alert. The alert will not sound.
3. Press the SNOOZE/BACKLIGHT button to exit.
10
High Alert Active Low Alert Active Both Alerts are O
To Next Page
Loading...
Need help?
General
