La Crosse Technology, Ltd. www.lacrossetechnology.com/support Page 9
Stucco has a metal mesh that absorbs signal.
Avoid transmitting antennas: (ham radios, emergency dispatch centers, airports,
military bases, etc.)
Electrical wires (utilities, cable, etc.)
Vegetation is full of moisture and reduces signal.
It is difficult for RF (radio frequency) signal to travel through a hill.
Temperature Alerts
Explanation: The outdoor and indoor temperature alerts are set in two separate steps.
Set the alert value.
Arm/Disarm the alert.
Select Temperature Alert Values:
1. Hold 2 seconds, then release the ALERTS button to enter alert set mode.
2. Outdoor HI TEMP will flash OFF or ON.
3. Press and release the +/- buttons to select ON.
(If disarmed (OFF) skip the alert value and move to next alert)
4. Press and release ALERTS button and alarm value will flash.
2. Press and release the +/- buttons to adjust values.
3. Press and release the ALERTS button to confirm adjustments and
move to the next item.
Alert setting order:
Outdoor Temp HI
Outdoor Temp LO
Outdoor Hum HI
Outdoor Hum LO
Indoor Temp HI
Indoor Temp LO
Indoor Hum HI
Indoor Hum LO
ARM/DISARM Alerts
Hold 2 seconds, then release the ALERTS button to view High and Low alerts with
flashing.
Press the PLUS button to arm an alert.
Press the MINUS button to disarm an alert.
Weather Station
Power Requirements
This weather station is powered by a 5 volt AC power adapter
Alternatively, optional 3-AAA alkaline batteries may be used.
12-Hour or 24-Hour time format
Time can display in 12-hour (am, pm) or 24-hour format.
To Next Page
Loading...
Need help?
General
