9
3. Press and release the SET button ten times.
4. “Sn” will appear in the DATE LCD and a number will be flashing next to it.
5. Press and release the ALM/+ button to select the duration of the snooze.
Note: The snooze can be set for 0 to 30 minutes in 5-minute increments. If 0 minutes is selected
pressing the WIND/SNZ button will deactivate the alarm and it will not come back on.
6. Press and release the SET button to confirm and advance to the forecast sensitivity setting.
X. SETTING THE FORECAST SENSITIVITY
Note: The forecast sensitivity can be adjusted to allow for areas that have a higher or lower
sensitivity to changing air pressure (for example coastal areas have more pressure change than
areas such as southern Arizona).
The numbers correspond to the amount of air pressure change necessary to trigger a change in
the forecast icon. Areas that tend to have more air pressure change would set the sensitivity to 3,
while areas that experience lower than normal air pressure change would set the sensitivity to 1.
1. Press and hold the SET button for 3 seconds.
2. “LCD” will show in the TIME LCD and the number setting will flash.
3. Press and release the SET button eleven times.
4. Either “1”, “2” or “3” will flash in the TIME LCD and the forecast icon and tendency arrows
will flash in the FORECAST LCD.
5. Press and release the ALM/+ button to select the forecast sensitivity.
6. Press and release the SET button to confirm the forecast sensitivity and complete the
programming.
FEATURES OF THE WS-9043U
WWVB Tower
Icon (indicates
time reception)
Radio-controlled
time icon
(indicates radio-
controlled time
turned on
To Next Page
Loading...
Need help?
General
