La Crosse Technology, Ltd Page 4
CAN I SHUT OFF THE WWVB SIGNAL?
• No. If you manually set the time, when the clock receives a WWVB signal, that
signal will override the manual set.
IS THERE A BOOSTER ANTENNA TO RECEIVE THE WWVB SIGNAL IN A
DIFFICULT LOCATION?
• No, the clock cannot work with a booster antenna.
• Opening the clock or movement voids the warranty.
CAN I WIRE A CONTROL TIMING CIRCUIT TO THE LA CROSSE
TECHNOLOGY
®
ATOMIC CLOCK?
• No, the clock cannot work on a timing circuit.
• Opening the clock voids the warranty.
WHY DO THE HANDS SPIN ONCE OR TWICE EVERYDAY?
• When the hands spin about the same time every day the clock is auto-correcting
the time. The hour hand should not spin more than twice around the clock.
• Hands may spin if the battery is underpowered or over powered.
• Use only Alkaline batteries in the clock.
HANDS SPIN NON-STOP
• This is indicative of a low or overpowered battery (number 1 warranty issue).
• Replace battery and perform restart procedure. Allow 5 days to catch the WWVB
signal
• If constant spinning continues, the movement may need replacement.
HANDS JUMPS OR JERKS AROUND THE DIAL
• This is indicative of a low or overpowered battery (number 1 warranty issue).
• Replace battery and perform the restart procedure
. Allow up to 5 days to receive
a signal.
• If the hands continue to jump, the movement may need replacement.
HANDS STUCK AT CERTAIN TIME
• This is indicative of a low or overpowered battery (number 1 warranty issue).
• Replace battery and perform restart procedure. Allow up to 5 days to receive a
signal.
• Check to see if the hands may be bent.
• Movement may need replacement.
POSITION THE CLOCK
• Select a location to place the radio-controlled clock where it will be at least six
feet away from a TV, computer, air conditioner or other household electrical
To Next Page
Loading...
Need help?
General
