La Crosse Technology WT-3129B User Manual

La Crosse Technology, Ltd Page 4
CAN I SHUT OFF THE WWVB SIGNAL?
 No.
If you manually set the time, when the clock receives a WWVB signal, that
signal will override the manual set.
IS THERE A BOOSTER ANTENNA TO RECEIVE THE WWVB SIGNAL IN A
DIFFICULT LOCATION?
 No
, the clock cannot work with a booster antenna.
 Opening the clock or movement voids the warranty.
CAN I WIRE A CONTROL TIMING CIRCUIT TO THE LA CROSSE
TECHNOLOGY
®
ATOMIC CLOCK?
 No
, the clock cannot work on a timing circuit.
 Opening the clock voids the warranty.
WHY DO THE HANDS SPIN ONCE OR TWICE EVERYDAY?
 Whe
n the hands spin about the same time every day the clock is auto-correcting
the time. The hour hand should not spin more than twice around the clock.
 Hands may spin if the battery is underpowered or over powered.
 Use only Alkaline batteries in the clock.
HANDS SPIN NON-STOP
 Thi
s is indicative of a low or overpowered battery (number 1 warranty issue).
 Replace battery and perform restart procedure. Allow 5 days to catch the WWVB
signal
 If constant spinning continues, the movement may need replacement.
HANDS JUMPS OR JERKS AROUND THE DIAL
 Thi
s is indicative of a low or overpowered battery (number 1 warranty issue).
 Replace battery and perform the restart procedure
. Allow up to 5 days to receive
a signal.
 If the hands continue to jump, the movement may need replacement.
HANDS STUCK AT CERTAIN TIME
 Thi
s is indicative of a low or overpowered battery (number 1 warranty issue).
 Replace battery and perform restart procedure. Allow up to 5 days to receive a
signal.
 Check to see if the hands may be bent.
 Movement may need replacement.
POSITION THE CLOCK
 This La Crosse Technology
®
atomic clock is designed for indoor or outdoor use.

La Crosse Technology WT-3129B Specifications

General

Brand	La Crosse Technology
Model	WT-3129B
Category	Clock
Language	English