Lab12 suono- 25W Class A Single Ended Power Amplifier
Page 4 of 9
Features
• 6550, KT88, KT120 compatible (KT150 from factory)
• Manual Bias Adjustment
• Triode / Ultra Linear selector switch
• No feedback design
• SRSG® implementation
• Fine symmetry® implementation
• Analog retro Nissei VU meters
• 5mm Aluminum face panel
• Five Years Guarantee
Installation & Placement
Lab12 suono should be placed on a solid flat surface. You should avoid placing it near a heat source as
this could compromise suono’s performance and reliability.
Carefully put the tubes in dedicated sockets. Make sure that the tubes are perfectly snap into sockets.
See bellow page.
Due to high power tubes’ design, suono’s chassis could be hot so you should never place another hot
component directly near this device. Make sure that the device has enough space to ventilate.
Tubes will be hot, this is normal. Be careful not to touch the tubes during the operation to avoid any
injuries.
Take care of the glass blasting anodized finish of front panel with a soft cloth. No need to use any sprays
or polishes. Never use cleaners containing abrasives, as this will damage the surface.
To Next Page
Loading...