10. Do not use this amplifier if the power cord is broken or frayed. Protect the power cord from
being walked upon or pinched particularly at the plugs and the point where it exits from the
apparatus.
11. Only use accessories specified by the manufacturer.
12. The unit is intended to use in a 19” rack. Follow the mounting instructions. When a rack on
wheels is used, use caution when moving the loaded rack to avoid injury from tipping over.
!
13. Unplug this apparatus during lightning storms or when unused for long periods of time.
14. Do not connect an amplifier output in parallel or series with any other amplifier’s output. Do
not connect the amplifier output to any other voltage source, such as battery, mains source, or
power supply, regardless of whether the amplifier is turned on or off.
15. Do not run the output of any amplifier back into another channel's input.
16. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has
been damaged in any way such as:
• Power-supply cord or plug is damaged
• Liquid has been spilled into the unit
• An object has fallen into the unit
• The unit has been exposed to rain or moisture
• The unit does not operate normally
• The unit was dropped or the enclosure is damaged
17. Do not remove top or bottom covers. Removal of the cover will expose hazardous voltages.
There are no serviceable parts inside and removal may void the warranty.
18. An experienced user shall always supervise this professional audio equipment, especially if
inexperienced adults or minors are using the equipment.
PKR= rëÉê=êÉëéçåëáÄáäáíó=
PKRKN= péÉ~âÉê=Ç~ ã~ÖÉ=
!
Your amplifier is very powerful and can be potentially dangerous to both, loudspeakers and
humans alike. Many loudspeakers can be easily damaged or destroyed by overpowering,
especially with the high power available from a bridged amplifier. Always check the speakers’
continuous and peak power capabilities.
Even if the amplifier’s front panel attenuators can be used to reduce the gain, it is still possible to reach
full output power if the input signal level is high enough.
PKRKO= péÉ~âÉê=çìíéìí=Ü~ ò~êÇ=
Power amplifiers are capable of producing hazardous output voltages. To avoid electrical s
do not touch any exposed speaker wiring while the amplifier is operating. See page 11
hock,
about
outputs for proper connection of speakers.
PKRKP= o~Çáç=áåíÉêÑÉêÉåÅÉ=
A sample of this product has been tested and complies with the limits for the European Electro
Magnetic Compatibility (EMC) directive. This equipment has also been tested and found to comply
with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference from electrical equipment. This
product uses radio frequency energy and if not used or installed in accordance with these operating
instructions, may cause interference to other equipment, such as radio receivers. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment on and off, the user is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Check if the affected unit complies with the EMC limits for immunity, (CE-labelled). If not,
address the problem with the manufacturer or supplier. All electrical products sold in the
i~ÄKÖêìééÉå== = = = = ====================== ========================P
rëÉê=j~åì~ä===Ñm=OOMM======sÉêëáçå=MKV========OMMPJNMJMT=
To Next Page
Loading...
Need help?
Power Output
Weight and Dimensions