Lab.gruppen PLM 10000Q User Manual

▸▸ 2350▸W▸per▸channel▸@▸2▸ohms**
▸▸ 2300▸W▸per▸channel▸@▸4▸ohms**
▸▸ 2U▸cha ssis▸weighing▸only▸13.5▸kg▸(30▸lbs)
▸▸ Cla ss▸TD
®
▸out put▸stage
▸▸ Reg ulated▸Switch▸Mode▸Power▸Supply▸(R.SMPS
™
)
▸▸ Copper-nned▸ Intercooler
®
▸ with▸ transverse-mounted▸ output▸
devices
▸▸ Full▸sui te▸of▸protection▸and▸fault▸monitoring▸features
▸▸ Comprehensive▸loudspeaker▸preset▸data base
▸▸ LoadLibrary
™
▸load▸“Fingerprint”▸( identity▸and▸characteristics)▸data
▸▸ Comprehensive▸ LoadSmart
™
▸ load▸ verication▸ and▸ SpeakerSafe
™
▸
continuous▸lo udspeaker▸performance▸monitoring
▸▸ Dante
™
▸low-latency▸digital▸network▸included▸as▸standard▸
▸▸ Fully▸ compatible▸ with▸ Dolby▸ Lake▸ Proc essor,▸ Lake▸ Contour
™
,▸
and▸Lake▸Mesa▸Quad▸EQ
™
▸and▸Mesa▸Parametic▸EQ
™
▸devices
▸▸ Primary▸and▸secondary▸network▸connections▸(for▸daisy▸chaining▸or▸
system▸redundancy)
▸▸ Digitally▸controlled▸”amplier▸gain”▸adjustable▸in▸0.1▸dB▸steps▸from▸
22▸to▸44▸dB
▸▸ Digital▸output▸attenuation▸in▸0.25▸dB▸steps▸from▸-inf▸to▸0▸dB
▸▸ Binding▸ post▸ or▸ Neutrik
®
▸ Speakon
®
▸ (1▸ x▸ NLT8,▸ 2▸ x▸ NLT4)▸ power▸
out put▸connectors▸
▸▸ Digitally▸implemented,▸zero-overshoot▸ Inter-Sample▸ Voltage▸Peak▸
Limiting▸(ISVPL
™
)▸adjustable▸in▸0.1▸V▸steps▸from▸17.8▸to▸153▸V▸
▸▸ Power▸Average▸Limiter▸(PAL)▸
▸▸ High-brightness▸front-panel▸LCD▸display
▸▸ Moisture▸resistant▸silicone▸touchpad▸for▸front-panel▸display▸mode▸
selection▸and▸menu▸nav igation
**▸▸More▸power▸available▸when▸driven▸asymmetric ally.
▸▸ Raised▸Cosine▸Equalization
™
▸▸ Linear▸phase▸and▸classical▸crossovers
▸▸ LimiterMax
™
▸–▸peak▸and▸RMS▸limiters
▸▸ Iso-Float
™
▸ground▸isolat ion
▸▸ Super▸Module▸capability
▸▸ Integration▸ of▸ third▸ party▸ frequency▸ measurement▸ and▸ analysis▸
system▸via▸the▸Lake▸Analyzer▸Bridge
▸▸ Analog▸and▸AES▸digital▸inputs▸with▸loop-thru▸outputs
▸▸ Auto-select▸input▸router▸for▸all▸inputs▸with▸user▸denable▸priorities▸
PLM 10000Q Powered Loudspeaker Management system
The▸ two-▸ input,▸ four-▸ output▸ PLM▸ 10000Q▸ seamlessly▸ integrates▸▸
networked▸digital▸signal▸distribution,▸drive▸processing,▸power▸ampli-
cation,▸and▸load▸veri cation▸plus▸performance▸monitoring▸in▸a▸single▸
hardware▸ unit▸ an d▸ unied▸ software▸ controller.▸ This▸ new▸ a pproach,▸
designated▸Powered▸Loudspeaker▸Management▸(PLM),▸is▸a▸co hesive▸
blend▸of▸ Lake
®
▸Processing▸ and▸Lab.gruppen▸power.▸ As▸a▸complete▸
system,▸ the▸ PLM▸ 10000Q▸ affords▸ signicant▸ benets▸ when▸ com-
pared▸to▸conventional▸approaches▸utilizing▸separate▸components.
Lab.gruppen Technology
Lake Processing Technology
PLM 10000Q
Technical Data
PLM
™
Series: Powered Loudspeaker Management
™

Lab.gruppen PLM 10000Q Specifications

General

Number of channels	4
Total output power	10000 W
Total Harmonic Distortion	<0.1%
Analog inputs	4 x XLR
Digital inputs	AES/EBU, Dante
Networking	Ethernet
DSP	Yes
Input Connectors	XLR
Voltage Range	100-240V

Summary

Power Amplifier

Power Amplifier Technology

Enhanced output power, Class TD, R.SMPS, Intercooler, protection features, PAL.

Load Verification and Performance Monitoring

LoadSmart

Compares predicted response to actual using LoadLibrary for problem identification.

SpeakerSafe

Real-time monitoring for power compression and driver integrity.

Lake Processing

Lake Processing Features

Includes EQ, linear phase crossovers, LimiterMax, and Iso-Float ground isolation.

Lake Controller Software

Software Interface

Unified interface for PLM and Dolby Lake processors, network control.

Super Module Functionality

Allows single module interface to control output channels in different PLM units.

Lake Analyzer Bridge

Seamless integration with third-party measurement and analysis software.

Dante Digital Audio Network

Dante Audio Networking

Self-configuring digital audio distribution over Ethernet with low latency.

Front Panel Controls

User Interface

Intuitive menu-driven interface with moisture-resistant touchpad and LCD.

Rear Panel Connectors

Connectivity Options

Binding posts or Neutrik Speakon, Analog XLR, AES/EBU, EtherCon, PowerCon.

Specifications PLM 10000Q

General Specifications

Input/output channels, peak output power, voltage, and current ratings.

Audio Performance Metrics

THD+N, dynamic range, and frequency response figures.

Limiters and Protection

ISVPL, Current Peak/Average Limiters, LimiterMax, MaxRMS, MaxPeak.

Back Panel Interface

Details on input/output connectors, control, and mains connections.

Front Panel User Interface

Display, indicators, buttons, and rotary encoder functions.

Approvals and Certifications

Compliance with CE, ANSI/UL, CSA, and FCC standards.