Need help?Do you have a question about the Lab.gruppen PLM Series PLM 10000Q and is the answer not in the manual?
General| Output Power (per channel at 2 ohms) | 2500 W |
|---|---|
| Output Power (per channel at 4 ohms) | 2300 W |
| Output Power (per channel at 8 ohms) | 1250 W |
| Output Power (per channel at 16 ohms) | 625 W |
| Total Output Power | 10000 W |
| Number of channels | 4 |
| Sample Rate | 96 kHz |
| Latency | 1.5 ms |
| THD+N | <0.1% |
| Damping Factor | > 500 |
| Dimensions | 88 x 483 x 396 mm |
| Cooling | front-to-rear airflow |
| Protection | DC, thermal, short circuit |
| Connectors | SpeakON |
| Voltage | 100-240 V AC |
| Signal to Noise Ratio | >112 dBA |
| Input Impedance | 20k ohms (balanced), 10k ohms (unbalanced) |
Provides an overview of the Lab.gruppen PLM Series systems and the manual's scope.
Details the available installation methods for the DLC PLM Edition software.
Describes the straightforward procedure for installing the software for the first time.
Explains how to replace an existing DLC installation with the PLM Edition.
Guides on installing the PLM Edition separately from an existing DLC installation.
Instructions for transferring user presets and files between different software installations.
Details basic operating parameters and control features accessible via software and front panel.
Explains supplementary PLM Module files enhancing DSP parameters and PLM-specific data.
Describes the system for verifying loudspeaker loads connected to PLM output channels.
Covers the real-time performance monitoring and logging feature for PLM output loads.
Explains how to access and navigate the software's Amplifier Module View and Global View.
Details the display of output channel status, including meters, attenuation, mute, phase reverse, and data blocks.
Describes controls for power, amplifier gain, ISVPL, and amplifier clip levels for output channels.
Covers loudspeaker load verification (LoadSmart) and settings, including cable data, verification, and results.
Explains how to view logs of PLM operational parameters graphically over time, including curves and channel data.
Details the listing and filtering of faults and warnings for selected modules and power output channels.
Provides system-wide control for power status, ambient temperature, and global LoadSmart verification.
Presents a system-wide event log listing warnings, faults, and user actions across all devices, with filtering options.
Describes the continuous logging of faults to XML files and their location for analysis.
To Next Page
