Need help?Do you have a question about the Lab.gruppen fP Series FP 2600 and is the answer not in the manual?
Provides essential instructions for safe operation and future reference.
Explains Stereo, Tandem, and Bridge mono operating modes.
Explains balanced and unbalanced audio input connections.
Details connecting loudspeakers using Neutrik® Speakon connectors.
Lists precautions for safe operation and describes the power-up sequence.
Details key protection mechanisms against clipping, heat, VHF, and shorts.
General| Number of Channels | 2 |
|---|---|
| Output Power Bridged (8 ohms) | 2600 W |
| Signal-to-Noise Ratio | > 100 dB |
| Damping Factor | > 500 |
| Input Sensitivity | 1.4 V |
| Voltage Gain | 32 dB |
| Connectors (Output) | Binding Posts |
| Output Power (2 Ohms) | 2600 W |
| Frequency Response | 20 Hz - 20 kHz |
| Total Harmonic Distortion | <0.1% |
| Input Impedance | 20 kΩ |
| Connectors (Input) | XLR |
| Protection | Short circuit, thermal, overload |
| Connectors | XLR |
| Dimensions (W x H x D) | 483 x 88 x 400 mm (19" x 1.75" x 15.75") |
To Next Page
