Need help?Do you have a question about the Lab.gruppen FP14000 and is the answer not in the manual?
General| Total Harmonic Distortion | < 0.1% |
|---|---|
| Damping Factor | > 500 |
| Output Power (2 Ohms) | 7000 W per channel |
| Output Power (16 Ohms) | 800W |
| Output Power (Bridged 4 Ohms) | 14000 W |
| Frequency Response | 20 Hz - 20 kHz |
| Input Impedance | 20 kOhm |
| Dimensions | 483 x 88 x 396 mm |
| Cooling | Temperature controlled fan |
| Protection | thermal protection |
| Power Supply | 100-240V, 50-60Hz |
| Signal to Noise Ratio | > 112 dBA |
Details the power output capabilities in various stereo and bridged mono configurations.
Specifies the frequency response range and the signal-to-noise ratio.
States the input impedance and the types of output connectors used.
Provides the physical dimensions and weight of the amplifier.
Highlights critical electrical safety precautions and warnings for user protection.
Provides crucial usage advice to prevent damage, hazards, and ensure proper function.
Explains how to operate the amplifier in independent stereo mode for each channel.
Details how to bridge channels for increased power output and control.
Describes balanced XLR, unbalanced, and Speakon connections.
Details level controls, indicators (PRO, Clip, SIG, TEMP, etc.), and power switch.
Identifies mains input, fuse, DIP switches, and various connector types.
Explains DIP switch settings for gain adjustment and bridge mode.
Describes VCL adjustments for speaker protection in normal and bridge modes.
To Next Page