LABEL-AIRE Write-up 3138NV-DAT - EXTENDED SWING TAMP SHOCK ABSORBER

52

9.Connect the compressed air service and dispense several labels to check the retracted tamp
position. Make additional adjustments as required.
EXTENDED SWING TAMP SHOCK ABSORBER
Figure21ExtendedSwingTampShockAbsorber
The following procedure
should only be performed by a Qualified
Service Technician.
1. Disconnect the compressed air service.
2. Pull the tamp assembly to the extended
position.
3.Refer to Figure 21. Loosen the swing tamp
shock absorber jam nut.
4.Thread the shock absorber completely out of
the mounting bracket.
5.Loosen the locking set screw 1/4 to 1/2 turn
on the shock absorber setting dial.
NOTE: DO NOT completely remove the
set screw. There is a nut plate inside the
shock absorber that may be irretrievable.
6.Set the cushioning setting dial to 4 1/2.Lock
the set screw.
7.Thread the shock absorber into the mounting
bracket. Do not tighten the jam nut.

