Labsphere RSA-PE-20 User Manual

AQ-00073-000, Rev. 7 2
Unpacking and Inspection
The RSA-PE-20 was thoroughly inspected and calibrated before shipping and should be ready to
operate after completing the set-up instructions. All Labsphere instrumentation is packaged and
shipped in reinforced shipping containers. The RSA-PE-20 is sold in two different configura-
tions, depending on the source of your order and the model number of your PerkinElmer UV/
VIS spectrometer. Carefully check the components after unpacking for any damage that may
have occurred during shipping. If there is any such damage, file a claim immediately with the
freight carrier and contact the Labsphere Customer Service Department at
!
(603) 927-4266.
Standard components accompanying all orders:
• RSA-PE-20 Accessory
• One 8
°
and two 0
°
sample holders
• Accessory cable assembly
• Cuvette Holder
• Tool Kit
• USRS-99-010 Uncalibrated Spectralon Reflectance Standard
• Instruction Manual
If your system was ordered directly from Labsphere, an instrument modification kit will accom-
pany the accessory and the components listed below will be labeled by Labsphere part number. If
your RSA-PE-20 was ordered through your PerkinElmer representative, the modification kit will
be provided directly from PerkinElmer and installed by their qualified technician.
• Accessory PC Board Kit part No. AS-00820-000 for use with Lambda 2 and
Lambda 12 model spectrometers
• RSAPE20 wiring harness Part No. AS-01803-000 for use with the Lambda 14
spectrometer
Optional Components
• Calibrated SRS-99-010 Spectralon Reflectance Standard
• Custom sample holders

Labsphere RSA-PE-20 Specifications

General

Brand	Labsphere
Model	RSA-PE-20
Category	Laboratory Equipment
Language	English