LED Status and Power
Status LED behavior
The status LED below the protective casing indicates the status of Rugged RAID Pro.
LED State
On The device is ready.
Blinking The device is being accessed.
Fast blinking A drive is not ready or has failed.
Off Device inactive because it’s turned off or in power-saving mode.
Contact LaCie technical support if:
The status LED remains off while the device is connected to a power supply and to your computer.
Confirm that Rugged RAID Pro is not in power-saving mode before contacting LaCie technical support.
The status LED continues to blink rapidly. One or both of your hard drives may have failed. Do not swap
one or both hard drives onsite or in the field. Doing so will void Rugged RAID Pro’s warranty.
Power LED behavior
Rugged RAID Pro is designed to operate using power from the connection to your computer. If the
connection isn’t delivering enough power for Rugged RAID Pro to operate, the power LED below the
protective casing blinks.
To Next Page
Loading...
