20-18071 Rev A
Emptying Fluid System
After the fluid system has been used, drain the internal fluid
tank. The Fluid System should be cleaned thoroughly once or
twice a month.
Emptying Internal Fluid Tank
1. Connect an empty fluid fill bottle to Fluid Inlet.
2. Fluid from the internal tank will automatically drain into
the fill bottle.
3. When the flow stops, disconnect the fluid connector.
Note
Place the fill bottle on the floor or below the Patient Simulator to
facilitate emptying the fluids.
Warning
Connecting a full fill bottle to a Patient Simulator with an already
full internal tank will result in system overflow. Fluid will drain out of
the right leg. Repeatedly overflowing the system may damage the
product.
How-To Videos
To Next Page
Loading...
