5
INTRODUCTION
1.3 PROPER USE
The three disc sanding machine TRIO is suitable for the dry sanding
of all kinds of wooden floors or cork floors in a dry environment.
It may be used to apply viscous polish or cleaning agent, or to
wax polish the floor. Additional tools such as milling discs or steel
brushes are available for dry work on composition floor or other
sub-floors.
Do not use TRIO for any other purpose without agreement by the
manufacturer. No wet sanding!
1.4 SAFETY PRECAUTIONS
Please read the following paragraphs carefully and instruct your
personnel and colleagues accordingly. Otherwise you or they might
risk incurring health hazards or injuries.
The machine must not be switched on in a tilted position since you
could be seriously injured by the rotating discs!
Please use only original LÄGLER tools, accessories and spare parts.
Warranty will not be granted if parts from other manufacturers are
used! Otherwise, damage to the machine and the surface worked
upon or danger for the operator cannot be ruled out.
Make sure you fit the dust bag carefully and correctly to prevent
unnecessary and harmful dust emissions for the operator and the
environment.
Never work with the wing nut and cleaning slide of the filter unit
pulled up, and observe the filter cleaning instructions to prevent
clogging of the filter/separator system.
Clogging can otherwise make troublesome and time-consuming
cleaning work necessary.
Improper transport can cause damage to the machine.
In order to preclude any damages by fire or explosion, the dust
bag must be removed, sealed and deposited in a non-combustible
container outdoors after each work period!
Keep away from sources of fire.
Do not smoke when in a dusty environment (e.g. during work or
when emptying the dust bag) danger of dust explosion.
1
The TRIO three disc sanding machine can
only be used for dry sanding. Never use it
to carry out wet sanding jobs of any kind
(Mortal danger)!
Not to be used for wet sanding of any
kind!
When the machine is switched on, a con-
siderable residual risk must be taken into
account despite all the safety devices. For
this reason, never reach into rotating tools
and machine parts!
To Next Page
