8
Application fields
• Wooden fl oor fi nishing
• Intermediate varnish sanding
• Refurbishing pre-fabricated parquet
• Sanding cork fl oors, mastic and fi ller surfaces
• Roughing subfl oors
• Removing dirt, glue, carpet and felt residue
• Application of cleaning agents, polish and cold wax
• Dry polishing of the surface
Not to be used for wet sanding jobs of any kind!
Basic configuration
TRIO machine ready to use, 1 supplementary weight 9 kg, 1 set
of sanding plates for Velcro discs and mesh discs, extension ca-
ble 10 m, 3 x 2.5 mm² with strain relief; 25 dust bags; 1 MultiClip;
1 Phillips screwdriver; 1 closed mouth wrench; 2 open end wrenches
SW 17; 1 hex. socket screw wrench 4 mm; 1 hex. socket screw
wrench 5 mm; 1 hex. socket screw wrench 6 mm, 1 operating in-
structions.
Special accessories
3 milling discs with 3 reversible holders each, 3 brush discs, 3 steel
brushes.
Wearing parts or safety-related parts
Please check the condition of the wearing parts listed below at
regular intervals to make sure you are working with a safely func-
tioning and optimally adjusted machine at all times:
• Replace extension cable if damaged
• Replace power cable if damaged
• Replace switch if damaged
• Replace Velcro sealing tape if damaged
• Replace MultiClip if damaged
• Replace V-belt when worn out
• Replace rubber jig when worn out
• Replace pad base of mesh sanding plate when worn out
• Replace sealing felt on cover when worn out
TECHNICAL DATA
2
The relevant part numbers for the special
accessories and wearing parts can be found in
the spare parts lists in Section 11.
To Next Page
