UNPACKING
Your DFLUX Cyclone comes packed in a single box. Before attempting to
assemble this machine, follow these directions for unpacking:
1. Carefully cut the banding straps and remove them from the box.
2. Cut along the tape line at the top of the box.
3. Remove all parts from the top of the foam and set aside.
4. Remove the foam packing material from the top of the machine and set
aside for further use, during assembly.
5. Cut the cardboard box (top to bottom) in the four corners for easy
removal of the box.
6. Carefully take out the machine components from the box and set aside.
7. Using the diagram below, ensure that all parts are present and in good
condition.
Report any missing or damaged parts to your dealer or distributor. Prior to
tool assembly and use, read this manual thoroughly to familiarize yourself
with proper assembly, maintenance and safety procedures.
Inventory DFLUX3
(DFLUX1 similar, not identical)
Components DFLUX3, DFLUX1 similar
To Next Page