Laguna Tools DFLUX1 - Maintenance; Cleaning the Filter

28
2. Confirm the electrical supply is correct and connected to machine.
3. Make sure no one is working on or doing maintenance to dust collector.
4. To start, press the ON button on either the ON/OFF switch or remote
control.
5. To stop, press the OFF button on either the ON/OFF switch or remote
control.
MAINTENANCE
CLEANING THE FILTER
To ensure proper operation of this Mobile Dust Cyclone, the pleated canister
filter must have adequate air flow. This means the filter must be regularly
maintained.
DISCONNECT MACHINE FROM POWER!
The filter cleaner crank knocks dust particulate and small debris from the
pleated filter and into the filter bag. To improve the effectiveness of the
paddles, slowly rotate the handle while simultaneously blowing, with
compressed air, (from outside – in) into the pleats. This will assist the
release of fine dust from the inside of the pleats. NOTE: using the blowing
function, (hose connected to exhaust port) of a vacuum cleaner, can also
help dislodge dust, if compressed air is not available.
To keep your machine in good working condition, it is recommended to use
the filter cleaner crank to clean the filter after every use.
To clean the filter using the crank simply rotate the crank handle back & forth.
NOTE: Excessive turning of the filter cleaner crank or fast turning will
prematurely wear the interior of the pleated filter.
EMPTYING OR REPLACING THE FILTER BAG
Periodically check the filter bag, if it is more than one third full, it is
recommended that you empty it.
NOTE: If the filter bag gets too full, the weight may force it to pull away
from the band clamp, exposing the user to potentially harmful particulates.
1. Turn Power off and unplug collector.
2. Release the band clamp at the bottom of the filter and remove the filter
bag.
3. Empty or replace the filter bag and re-attach using the spring-loaded
band clamp.
I
GU\IA
&CAUTION