SAVE THESE INSTRUCTIONS
1. Read and understand the warnings posted on the machine and in this
manual. Failure to comply with all of these warnings may cause
serious injury.
2. Replace the warning labels if they become obscured or removed.
3. This Dust Collector is designed and intended for use by properly
trained and experienced personnel only. If you are not familiar with
the proper and safe operation of this type of dust collector, do not use
until proper training and knowledge have been obtained.
4. Do not use this machine for other than its intended use. If used for
other purposes, LAGUNA TOOLS INC., disclaims any real or implied
warranty and holds itself harmless from any injury that may result
from that use.
5. Always wear approved safety glasses/face shields while using this
machine.
6. Before operating this dust collector, remove tie, rings, watches and
other jewelry, and roll sleeves up past the elbows. Remove all loose
clothing and confine long hair. Non-slip footwear or anti-skid floor
strips are recommended. Do not wear gloves.
7. Wear ear protectors (plugs or muffs) during extended periods of
operation.
PROPOSITION 65 WARNING:
8. Some dust created by power sanding, sawing, grinding, drilling and
other construction activities contain chemicals known to cause cancer,
birth defects or other reproductive harm. Some examples of these
chemicals are: (next page)
• Lead from lead based paint.
• Crystalline silica from bricks, cement and other masonry
products.
• Arsenic and chromium from chemically treated lumber.
Your risk of exposure varies, depending on how often you do this type
of work. To reduce your exposure to these chemicals, work in a well-
ventilated area and work with approved safety equipment, such as
face or dust masks that are specifically designed to filter out
microscopic particles.
9. Do not operate this machine while tired or under the influence of
drugs, alcohol or any medication.
10.Make certain the switch is in the OFF position before connecting the
machine to the power source.
11.Make certain the machine is properly grounded.
12.Make all machine adjustments or maintenance with the machine
unplugged from the power source.
13.Form a habit of checking to see that all extra equipment such as
adjusting keys, wrenches, scrap, stock, and cleaning rags are removed
away from the machine before turning on.
To Next Page
Loading...