laguna MDCCF32201 - Step-by-Step Assembly Guide

3HP Mobile Dust Cyclone Manual
13
UNPACKING
Your 3HP Mobile Dust Cyclone comes packed in a single box. Before attempting to
assemble this machine, follow these directions for unpacking:
1. Carefully cut the banding straps and remove them from the box.
2. Cut along the tape line at the top of the box.
3. Remove all parts from the top of the styrofoam and set aside.
4. Remove the styrofoam packing material from the top of the machine.
5. Carefully take out the machine components from the box and set aside.
6. Using the diagram below, ensure that all parts are present and in good condition.
DESCRIPTION (QUANTITY) Figure 1
A. Motor
B. Switch and remote controller
C. Dust chute
D. Top upright supports (3)
E. Canister 1 Micron
F. Base frame
G. Octagon front and back panel
H. Octagon drum side panels
I. Octagon drum lid
J. Cyclone funnel
K. Cyclone barrel
L. Intake cylinder
Report any missing or damaged parts to your dealer or distributor. Prior to tool
assembly and use, read this manual thoroughly to familiarize yourself with proper
assembly, maintenance and safety procedures.
G
J
K
J
K
J
I
N
P
P
R
S
T
T
T1
T2
T
3
Hardware
box
Manual
M. Canister cover plate
N. Octagon drum foot peddle
O. Inlet adapter
P. Lower upright supports (3)
Q. Drum insert
R. Upright support reinforcement plate (3)
S. Foot peddle bar (left and right)
T. Foot peddle assembly fittings
T1. Lower triangular support plate (2)
T2. Foot peddle bar support (2)
T3. Lower support plate (2)
U. Hardware box
V Operating and Parts Manual
U
V
A
B
C
D
M
E
L
O
F
Q
G
H