14
!"
Check the link cables for continuity with a multi-meter if a cable problem is
diagnosed.
!"
If there are still problems linking a large bank of machines, try linking the
‘OVEHEAD JACKPOT DISPLAY’
machine with just one machine at a time to
check there is not an internal problem with any one machine. After linking two
machines successfully, try introducing other machines one at a time.
!"
A single machines internal linking hardware and cables can be checked by setting
the single machine to
‘MASTER’
and looping the cable from
OUT
to
IN
as per
the diagram below:
!"
Turn the single machine off and on and the 3 digit display should show the
following sequence:
!"
If an error occurs, this would mean that the single link cable is faulty, or
the internal machine hardware is faulty. (If the machine hardware is faulty, contact
your nearest LAI Games Distributor).
* NOTE:
If games will not link, the
‘OVERHEAD JACKPOT
DISPLAY’
will try for approximately 60 seconds, and if unsuccessful, the
games will power up as solo machines and the overhead jackpot display will no
be active and continue to display Er4.
E r 4
* REMEMBER *
After performing this test, don’t
forget to set the machine back to
its correct P01 setting.
(
‘MASTER’
or
‘SLAVE’
)
OUT IN
SET TO
MASTER
1
0 0 0
To Next Page
Loading...
Need help?
General
