66
23.1 • ACTIVATING AUTOMATIC CLEANING CYCLE
Press the MENU button 13, turn knob 16 until
“Wash” is displayed and confirm by pressing
knob 16.
Turn knob 16, select the wash required
displayed on display 15 and confirm the start
by pressing knob 16.
If the programme ends correctly, a message is
displayed on display 15; press knob 14 to exit
the wash programme.
Cleaning programmes RINSE, ECO, SOFT,
HARD and HARD PLUS are an automatic
sequence of cycles (the duration and time
remaining until the end of the programme is
shown on display 15), resulting in a dry and
sparkling clean chamber.
If stubborn dirt residue is deposited on the
drainage filter located at the centre of the
cooking chamber base, clean in order to
guarantee the free flow of water and detergent.
The end of the programme is signalled by
a cyclical acoustic sound, open the door to
deactivate the sound.
It is prohibited to turn the oven off using
knob 16 while the following cleaning
programmes are under way: RINSE, ECO
WASH, SOFT WASH, HARD WASH, HARD
PLUS WASH and GRILL wash; wait for the
'cleaning complete' signal before turning
the oven off.
Pass a sponge or cloth over the front gasket of
the cooking chamber to prevent the premature
deterioration of the same.
Stop and shut off all supplies (electricity, water
and if present, gas). When not in use, the door
should be left slightly open.
SPECIAL PROGRAMMES
23 • CLEANING KIT
90034270rev02
To Next Page
Loading...
Need help?
General