Need help?Do you have a question about the Lambda Vega 650 and is the answer not in the manual?
Details on connecting the Vega power supply to the input AC supply and load.
Details on factory-fitted analogue primary option boards and their functions.
Explains the Global Inhibit and Enable logic and how to configure it.
Details on factory-fitted analogue secondary option boards and their functions.
Details 1+1 redundant and hot swap configurations using the 'N' option for current sharing.
Explains how to measure output ripple and noise using an oscilloscope.
Details the procedure and equipment for measuring output ripple and noise.
Details Mean Time Between Failures (MTBF) calculations using MIL-HDBK-217F.
Provides guidance on installing Vega power supplies for optimal EMC performance.
Explains how cable/PCB layout and filters enhance EMC performance.
Details on wide range programmable modules, their options, and configuration.
Describes the single slot W2 module, its range, and current capability.
Lists and describes various control options for programmable modules.
Describes the single slot W5 module, its range, and current capability.
Explains remote sense functionality and best practices for programmable modules.
General| Model | Vega 650 |
|---|---|
| Type | ATX |
| Maximum Power | 650W |
| Fan Size | 120mm |
| PCIe Connectors | 2 x 6+2-Pin |
| SATA Connectors | 6 |
| Molex Connectors | 3 |
| EPS Connectors | 1 x 4+4-Pin |
| Input Voltage | 100-240V |
| Input Frequency | 50-60Hz |
| Output | +3.3V@20A, +5V@20A, +12V@54A, -12V@0.3A |
To Next Page
