lamber M115 User Manual

20
AFTER WASHING OPERATIONS
PRECAUTION AND CLEANING
INSTRUCTIONS
1 – high temperatures can be reached
inside the machine (90°C). Affter
power supply has been removed, wait
until the machine has reached the
room temperature, before working on
it;
- never leave tools, parts or other loose
material on or in the machine;
- BEFORE starting machine or cycle,
after any maintenance or repair work,
make sure all protective are correctly
installed;
2 - Take off the machine by means the
disconnecting switch located on the
control panel.
3
- IMPORTANT: Before carrying-out the
cleaning and maintenance operations,
disconnect the equipment from the
mains voltage through the wall-
mounted on/off switch and close the
water and steam* supply cocks;
4
- Lift the inspection doors making sure
that they are firmly linked to the
apposite support.
.
5
- Wash the inside of the machine with
a water jet. When everything is
clean and water is completely
drained, take out and clean carefully
the flat filters and that of the pre-
wash (if any) and wash them
carefully every day (don't beat them
against the floor or others) .
6 – When the tanks are empty remove
and wash the slide filters and the
suction pump filters .
7 – Remove and wash the splash-guard
curtains.
8 - For machines with steam
condensation only, remove the
steam aspiration filter (fig.5) end
clean it.
9 - Check that the washing nozzles are
not clogged. If necessary,
disassemble the nozzles and pay
attention to assemble them again in
the right position (twice a week).
10 - Remove the rinsing arms by rotating
them counter-clockwise and check
that the nozzles are not clogged: if
otherwise, clean them using a
needle (every week).
11 - Replace the filters taking care that:
Curtains
shall have their shortest
side turned towards the basket inlet
(see the blue signalling marks
located on the doors)
12 - Clean the outside part of the
machine using a wet sponge .Don't
use water jets that, beside being
dangerous, could also damage the
electrical parts.
Don't use detersive, abrasives, steel-wools
or steel-brushes.
14 – In order to avoid the formation of
nasty smells, let the doors open
making sure that they are firmly
linked to the apposite supports.
* for steam machines only

lamber M115 Specifications

General

Brand	lamber
Model	M115
Category	Dishwasher
Language	English