B - Check that the filter of the condenser battery is not clogged by fat residuals. In such an
event, wash it with boiling water and detersive. Rinse thoroughly.
C - Check that overload cutout is not triggered. If so, restore it. This drawback is dispalyed by
lamp M(LS3) being ON .
D - Check that fuses and remote switch coil MT16 are not broken.
E - Check that motor M08 is not blocked nor burnt and rotates in the right direction
F - Check that the cold water feed cock is open and water is present at a pressure of at least
2 bars.
G - Check that cold water inlet filter D is not clogged to such an extent as to limit the flow
rate.
The manufacturer declines any responsibility for any misprints contained in this
booklet. The Manufacturer also reserves the right to make any modifications to its
products that don't affect the basic characteristics thereof.
To Next Page
Loading...
Need help?
General
