20
C) – WARNING! If the
gasket has to be
replaced because it is
broken, proceed
according to the
sequence illustrated
below.
c.1- Use the gasket provided
(Warning! The gasket should
only be put on one of the
surfaces of the modules to be
joined)
c.4- Use a pick to perforate
the gasket in the area of the
existing holes.
c.2- Spread the adhesive
gasket provided on the side
wall of one of the modules.
c.5- Make sure that the
gasket is correctly positioned
in correspondence with the
corners.
c.3- Cut the gasket. Repeat
this operation for the 4
external edges.
To Next Page
Loading...
Need help?
General
