35
WASHING AUTOTIMER (optional)
Thanks to the AUTOTIMER device it is
possible to reduce water and power
consumption when the machine is not used.
To activate this function, push the button “R”
(led on).
HEAT PUMP (optional)
The system exploits the heat produced in the
cooling cycle, which allows to constantly
regenerate energy from the hot air produced in
the machine, to preheat the rinsing water.
This device allows to feed the machine with
cold water, so as to save a lot of energy ( al
least 15,5 Kw).
FLOWMETER RINSING (optional)
It checks the water flow is enough for a good
final rinsing cycle. The blinking led “M”
indicates a possible failure.
PREWASHING CORNER TUNNEL (optional)
If a PRE-WASH CORNER TUNNEL is
installed, the machine indicates when it is
possible to insert the basket into the corner
tunnel.
The led “L” .marked with the symbol ( )
lights up when there is a basket inside the
corner tunnel.
Once the transport slide has been completed
and the tunnel is free, the led “L” goes off: this
indicates that it is possible to insert another
basket.
"Attention! This unit cannot be connected
to any automatic basket loading system.
Baskets can be introduced only by hand
and by an operator.".
To Next Page
Loading...
Need help?
General
