www.howdens.com
Built-in Combination Microwave Oven LAM7004 LAM7005
Instructions and Installation
16 17
Waste regulation
Disposing of the old product. Compliance with the WEEE Directive
and disposing of the waste product:
This product complies with EU WEEE Directive (2012/19/EU).
This product bears a classification symbol for waste
electrical and electronic equipment (WEEE).
This product has been manufactured with high quality
parts and materials which can be reused and are suitable
for recycling. Do not dispose of the waste product with
normal domestic and other wastes at the end of its
service life. Take it to the collection centre for the recycling
of electrical and electronic equipment. Please consult your local
authorities to learn about these collection centres. Appropriate disposal
of used appliance helps prevent potential negative consequences for
the environment and human health.
Compliance with RoHS Directive:
The product you have purchased complies with EU RoHS Directive
(2011/65/EU). It does not contain harmful and prohibited materials
specified in the Directive.
Package information
• Packaging materials of the product are manufactured from recyclable
materials in accordance with our National Environment Regulations.
Do not dispose of the packaging materials together with the domestic
or other wastes. Take them to the packaging material collection
points designated by the local authority.
Future transportation
• Keep the product’s original carton and transport the product in it.
Follow the instructions on the carton. If you do not have the original
carton, pack the product in bubble wrap or thick cardboard and
tape it securely.
Check the general appearance of your product for any
damages that might have occurred during transportation.
2. Environmental instructions
Product introduction
3. Your product
11
Steam vent hole
Steam is vented from here
during microwave opera tion.
Condensation can form on
the surrounding surfaces.
* It depends on the model.
Your product may not have a
lamp, or the type and location
of the lamp may differ from
the illustration.
** It depends on the model.
Your product may be without
wire shelves. In the illustration,
wire shelves are shown as
examples.
1
2
7
6
5
4
3
10
11
8
9
1
Control panel
2
Wire shelves**
3
Fan motor
(behind steel plate)
4
Door
5
Handle
6
Bottom heater
(bottom steel plate)
7
Shelf positions
8
Lamp*
9
Top heater
10
Ventilation holes
To Next Page
Loading...
