7
Cold water supply
10-80 lpm.
REMOVE
CAP/END
WARNING! This appliance
must be earthed.
(Socket must be accessible
after fitting).
WARNING! Do not use extension
cables / adapters.
Ensure water is turned on and
the isolator valve is accessible
after fitting.
Hose connection - 3/4”.
Cold water pressure -
0.1 – 1Mpa (0.3 - 1.0 Bar)
Incorrect waste pipe configuration. Correct waste pipe configuration to avoid water flow
from the sink to dishwasher
Ensure cap/end is removed
from waste pipe spigot.
NOTE: Ensure hoses are not
kinked or trapped behind
the dishwasher.
NOTE: If necessary loosen and
rotate the water hose towards
the water supply and re-tighten.
(Always use the new hose supplied
with the dishwasher).
NOTE: Issues with hoses or drain will cause machine to malfunction.
To Next Page
Loading...
