Lamtec FMS 4 - FMS Operating Principle; FMS Digital Inputs; FMS operating sequence

10
4 System Operation
4.3.2 Reading Faults
Red LED fault lights up
Switch (1) to STATUS
 Fault code is displayed
Note code and firing rate values (external and internal).
Press Enter (3)
 The display shows plain text message including running time meter reading up to the time
of the fault
A list of the fault codes, error texts and help can be found in the document "Commissioning
Supplement List of Fault Codes for FMS/VMS/ETAMATIC/ETAMATIC OEM/FA1" (Publication
no. DLT1050).
4.3.3 Resetting Faults
Switch to STATUS.
Left-hand switch up
 the fault is cleared unless the cause is still directly present.
Alternative:
FMS: Set signal on terminal 2 briefly (min. 2 seconds) via external switch.
 Fault is cleared!