20
3 System Operation
201* 1st monitoring band under range too long: channel 1 B1,B3
202* 1st monitoring band under range too long: channel 2 B1,B3
203* 1st monitoring band under range too long: channel 3 B1,B3
204* 1st monitoring band under range too long: channel 4 B1,B3
205* 1st monitoring band under range too long: channel 5 B1,B3
211 2nd monitoring band over range too long: channel 1 E11,B5
212 2nd monitoring band over range too long: channel 2 E11,B5
213 2nd monitoring band over range too long: channel 3 E11,B5
214 2nd monitoring band over range too long: channel 4 E11,B5
215 2nd monitoring band over range too long: channel 5 E11,B5
221 2nd monitoring band under range too long: channel 1 E11,B5
222 2nd monitoring band under range too long: channel 2 E11,B5
223 2nd monitoring band under range too long: channel 3 E11,B5
224 2nd monitoring band under range too long: channel 4 E11,B5
225 2nd monitoring band under range too long: channel 5 E11,B5
231** Compound blocked: channel 1 E2, E4,
E5, C1,
B1,B 3
232** Compound blocked: channel 2 E2, E4,
E5, C1,
B1, B3
233** Compound blocked: channel 3 E2, E4,
E5, C1,
B1, B3
234** Compound blocked: channel 4 E2, E4,
E5, C1,
B1, B3
235** Compound blocked: channel 5 E2, E4,
E5, C1,
B1, B3
301* Broken wire at load input channel 1 F2
302* Broken wire at load input channel 2 F2
320* Broken wire at correction input D7
321* Broken wire at feedback channel 1 E9
322* Broken wire at feedback channel 2 E9
323* Broken wire at feedback channel 3 E9
324* Broken wire at feedback channel 4 E9
325* Broken wire at feedback channel 5 E9
351* Non-permissible curve change while burner is operating G3
352** Invalid curve selection (no signals) G4
353** Invalid curve selection (several signals) G4
360 Shut down from O
2
controller(1) / CO.controller(2):
361 Different status of ignition position relay E6
362 Carry out burner servicing
Aids FMS Aids ETA
To Next Page
Loading...
Need help?
General
