To Next PageTo Next PageWhy is the driveline shaft telescoping tube wearing on my Land Pride Cutter?
The driveline shaft telescoping tube on your Land Pride Cutter might be wearing because it needs lubrication. Lubricate it every 8 hours of operation.
What causes a blade carrier to bend on my Land Pride RC5715 Cutter?
A bent blade carrier on your Land Pride Cutter is often caused by hitting solid objects. Avoid hitting solid objects to prevent this.
What causes excessive side skid wear on my Land Pride RC5715?
Excessive side skid wear on your Land Pride Cutter can be caused by abrasive soil. Adjust the cutter height to address this. Additionally, cutting too low can contribute to this issue, so raise the cutting height.
What to do if the wing cylinder movement is too slow on my Land Pride Cutter?
If the wing cylinder movement is too slow on your Land Pride Cutter, the orifice might be plugged. Remove the elbow fitting and unplug the orifice.
General| Power Requirement | 540 RPM |
|---|---|
| Number of Blades | 3 |
| Deck Thickness | 10 gauge |
| Cutting Width | 15 ft |
| Working Width | 15 ft |
| Hitch | Pull-type |
| Driveline Protection | Slip clutch |
| Transport Width | 72 inches |
