Why is my Land Pride RCR2660 Cutter driveline clutch slipping?
The driveline clutch in your Land Pride Cutter might be slipping due to several reasons: you may be scalping the ground, cutting too fast, engaging the power take-off too fast at high engine rpm, or cutting over solid objects. To resolve this, raise the cutting height, reduce your travel speed, slowly engage the power take-off at low engine rpm, and avoid solid objects.
What to do if Land Pride Cutter blades wearing excessively?
If the blades on your Land Pride Cutter are wearing excessively, it could be due to cutting on sandy ground or frequently contacting the ground. Try raising the cutting height to prevent this.
Why is my Land Pride RCR2660 Cutter vibrating excessively?
Excessive vibration in your Land Pride Cutter can be caused by several factors: a bent driveline, loose blades, a bent blade carrier, a broken blade, a blade that won't swing freely, or blades with unequal weight. To address this, replace the driveline, tighten the blade bolts, replace the blade carrier, replace the broken blade, remove and inspect the blade that won't swing, or replace both blades if they have unequal weight.
What to do if Land Pride RCR2660 Cutter oil seal leaking?
An oil seal leak in your Land Pride Cutter can occur if the gearbox is overfilled, the seals are damaged, or grass/wire is wrapped on the shaft in the seal area. Drain the gearbox to the side plug hole if overfilled, replace damaged seals, and check seal areas daily for any wrapped debris.
What to do if Land Pride RCR2660 blade carrier becomes loose?
If the blade carrier on your Land Pride Cutter becomes loose, it could be due to it running loose in the past or the blade carrier hardware not being tight enough. Replace the gearbox output shaft and blade carrier if it has been running loose. Otherwise, tighten the blade carrier hardware to the specified torque.
What to do if Land Pride Cutter driveline yoke or cross failing?
If the driveline yoke or cross is failing on your Land Pride Cutter, it may be due to shock load or a lack of lubrication. Avoid hitting solid objects and lubricate every 8 hours.
How to prevent Land Pride Cutter driveline telescoping tube failing?
To prevent the driveline telescoping tube from failing on your Land Pride Cutter, avoid hitting solid objects, as the failure is likely due to shock load.
What to do if Land Pride RCR2660 blade bolt holes worn?
If the blade bolt holes on your Land Pride Cutter are worn, it's likely due to the blade hardware running loose. Replace the blades and blade bolts if they are worn.
How to prevent Land Pride RCR2660 Cutter bent driveline?
A bent driveline on your Land Pride Cutter can occur if it is contacting the frame or drawbar, or bottoming out. Reduce the lift height in the transport position, reposition the drawbar, or shorten the driveline to resolve this.
How to prevent Land Pride RCR2660 Cutter driveline telescoping tube wearing?
To prevent the driveline telescoping tube from wearing on your Land Pride Cutter, ensure it is lubricated every 20 hours, as the wear is likely due to a lack of lubrication.
General| Model | RCR2660 |
|---|---|
| Category | Rotary Cutter |
| Number of Blades | 2 |
| Cutting Width | 60 in |
| Gearbox | 540 RPM |
| Cutting Height | 1-6 in |
To Next Page