LANDA PG 8.913-910.0
OPERATOR’S MANUAL
PRESSURE WASHER
6
COMPONENT IDENTIFICATION - 4-2000, 4-3500
CAUTION
Never Use
:
• Bleach, chlorine products and other corrosive chemicals
• Liquids containing solvents (i.e. paint thinner,gasoline,oil)
• Tri-sodium phosphate products
• Ammonia products
• Acid-based products
These chemicals will harm the unit and will damage the
surface being cleaned.
Use manufacturer's detergents as recommended in manual
READ OWNER'S MANUAL BEFORE OPERATION.
LIRE LE MANUEL D'UTILISATEUR AVANT USAGE.
VOR INBETRIEBNAHME UNBEDINGT
BEDIENUNGSANLEITUNG DURSCHLESEN.
NO UTILIZAR SIN ANTES NO HABER LEIDO EL MANUAL.
CHAUD!
Pump — Develops high pressure.
Starter Grip — Used for starting the engine manually.
Spray Gun — Controls the application of water and
detergent onto cleaning surface with trigger device.
Includes safety latch.
Detergent Injector — Allows you to siphon and mix
detergents.
Variable Pressure Wand — Must be connected to
the spray gun. Allows for detergent injection and lower
pressure by turning handle.
High Pressure Hose — Connect one end to water
pump discharge nipple and the other end to spray gun.
Pump Protector — Cycles water through pump when
water reaches 140°-145°F.
Note: If trigger on spray gun is released for more
than 1-2 minutes, water will leak from valve. Warm
water will discharge from pump onto floor. This
system prevents internal pump damage.
High
Pressure
Hose
Pressure Nozzle
Discharge
Nipple
Spray Gun
Variable Pressure Wand
4-3500
Inlet
Connector
Detergent
Injector
Quick
Coupler
Collar
Wand Coupler
Collar
Water Filter
Pump
Variable
Pressure
Handle
Starter
Grip
Safety Latch
Soap Nozzle
Straight Wand
4-2000
Detergent
Hose
Detergent Bucket
(not included)
Trigger
Trigger
Swivel
Connector
Unloader
Hose Hanger
To Next Page
Loading...
