Need help?Do you have a question about the Landice L7 and is the answer not in the manual?
General| Motor | 4 HP continuous duty |
|---|---|
| Running Surface | 20" x 58" |
| User Capacity | 400 lbs |
| Incline Range | 0% to 15% |
| Deck Thickness | 1" |
| Display | LCD |
| Speed Range | 0.5 - 12 mph |
| Programs | Varies by console (e.g., preset programs, custom programs, heart rate control) |
Instructions for checking and adjusting the drive belt tension.
Procedure for adjusting the treadbelt tension to prevent slippage.
Steps to adjust the treadbelt for proper tracking and alignment.
Procedure to test the drive motor's voltage generation capability.
Steps to test the elevation motor's input voltage and operation.
Procedure to test the elevation potentiometer for correct resistance readings.
Verifying the functionality of PWM and SCR motor control boards.
Procedure to verify the operation of the optical speed sensor.
Troubleshooting flowchart for ESI SCR boards with no power or blown fuses.
Troubleshooting flowchart for ESI PWM boards with no power or blown fuses.
Diagnosing loss of speed signal on ESI SCR boards where treadbelt does not move.
Diagnosing loss of speed signal on ESI PWM boards where treadbelt does not move.
Troubleshooting speed increase issues on ESI SCR boards.
Troubleshooting speed increase issues on ESI PWM boards.
Troubleshooting speed issues on PT4 models where treadbelt moves but speed is limited.
Diagnosing why the upper display fails to light on ESI SCR models.
Diagnosing why the upper display fails to light on ESI PWM models.
Resolving the 'Calibration in Progress' message during startup on PT4 models.
Troubleshooting the 'OFF' elevation error code on PT4 models.
Diagnosing 'PO' error or elevation system failures on ESI PWM models.
Procedure for removing and replacing the upper control panel assembly.
Guidance for accessing and replacing components within the lower control panel.
Procedure for replacing the safety switch assembly and its components.
Procedure for removing and installing the speed sensor.
To Next Page
