EasyManua.ls Logo

L&L EASY-FIRE e28S - Unpacking; Inspect for Visible Damage; Remove Top from Carton; Unpack Instructions, Vent and Furniture Kit

Default Icon
17 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ASSEMBLING YOUR L&L EASY-FIRE KILN
easy-fire-install.pdf 3/1/2007 Rev 1.3 Page 2
2007 L&L Kiln Mfg, Inc. 505 Sharptown Rd, Swedesboro NJ 08085 P:856.294.0077 F:856.294.0070 sales@hotkilns.com hotkilns.com
ASSEMBLING YOUR L&L EASY-FIRE KILN
UNPACKING
Inspect for visible damage
The carton should arrive without visible damage. If
the carton was damaged in transit, you should either
refuse shipment or unpack the kiln in the drivers
presence in order to file a damage report with the
freight company.
Call our office immediately if
there is a problem. SAVE ALL MATERIALS
UNTIL YOU ARE SURE YOU WON'T NEED
THEM. AT THE VERY LEAST NOTE DAMAGE
ON THE BILL- OF-LADING - WITHOUT THIS
YOU HAVE NO PROTECTION!
Below is a picture of how your kiln should arrive:
Remove Top from Carton
1) Remove the packing slip from the packing list
enclosed envelope, as well as the kiln set up instruc-
tions from the large envelope that is on the side of the
kiln carton.
2) Cut the banding around the kiln box and remove
the top.
3) You are looking at the heavy duty top of the kiln
stand. Remove it and set it off to the side.
Below is the first thing you will see when you
open the box - the top of the stand:
Unpack Instructions, Vent and Furniture Kit
1) Remove the corrugated pad from the inside of the
carton.
2) For all kilns you will find the following items:
a) spring hinge tool
b) instruction manual
c) stand legs with the mounting hardware
d) Training Video
3) If you ordered a Vent-Sure vent system you will
find the following items inside the cardboard insert:
a) flexible ductwork
b) bypass collection box
c) galvanized 90 degree elbow
d) vent motor with bracket that holds it to the wall
4) If you ordered the Furniture/Accessory kit you will
find the following:
For an e18S:
a) One 15-1/2'' full round shelf
b) four 15-1/2' half shelves
c) six each 1/2'', 1'', 2'', 4'', 6'' and 8'' square posts
d) five pounds of Cone 10 kiln wash
e) dark viewing glasses
d) a pair of temperature resistant gloves
e18S-3:
a) One 15'' full round shelf
b) four 15'' half shelves
c) six each 1/2'', 1'', 2'', 4'', 6'' and 8'' square posts
d) five pounds of Cone 10 kiln wash
e) dark viewing glasses