ASSEMBLING YOUR L&L EASY-FIRE KILN
easy-fire-install.pdf 3/1/2007 Rev 1.3 Page 9
2007 L&L Kiln Mfg, Inc. 505 Sharptown Rd, Swedesboro NJ 08085 P:856.294.0077 F:856.294.0070 sales@hotkilns.com hotkilns.com
Power Terminal Strip is shown :
4) Remove wires numbers 1 through 6 from both
sides of the Thermocouple Terminal Strip.
The Thermocouple Terminal Strip:
5) Remove the green ground that connects the front
panel to the rear panel.
Removing the ground wire:
6) Tilt the control panel halfway back to its original
position and gently pull the panel from the element
box and set aside. It will take a combination of pulling
slightly up and slightly out to disengage the control
panel from the element terminal box.
Removing the panel:
REMOVING ELEMENT COVER BOX
If you prefer you can remove the box using the
method shown on page 7 instead.
1) Remove the three screws on the right hand side of
the element box and set them aside.
Removing the right hand screws :
2) Loosen the 3 screws on the left hand side of the
element box but leave them in place. Loosen them to
about a ½ inch.
Loosen the left hand side
ASSEMBLING YOUR L&L EASY-FIRE KILN
To Next Page
Loading...