Lang GCCO-T - Start-Up

10
START-UPS
GCCO-AP / GCCO-C / GCCO-PP / GCCO-PT / GCCO-SII / GCCO-T
Convection Oven Start-Up
1) Verify connections at plug and terminal block
2) Incoming Gas - Water Column________
Natural Gas Propane
3) Incoming Voltage L1______
4) Motor amp draw ______
5) Are programs correct? Yes No
6) Verify actual temperature at 350 °F ________ °F.
Note:
Install thermocouple wire in center of oven cavity.
Let oven cycle off and on 3 times before recording temperature.
Set manual program in the computer for 350 °F
Model #_______ Date_______ Serial #________
Store #___________ Tech Name___________________
Contact_______________ Company _________________________
Store Phone #___________ Service Company Phone #______________
Address_____________________
______________________
______________________