19
PROGRAMMING GCCO-C CONT’D
GCCO-C STATUS DISPLAY
The Status Display informs the operator of the oven's status.
It can be used as a countdown timer, shelf in use or internal oven temperature display during the
cooking cycle (see GCCO-C Programming Codes).
The Display informs the operator when the oven is ready to bake, or if the oven is above or below the
programmed temperature.
Below is a list of displays and their definitions:
"
ENTER" The oven is energized and ready for an operator command.
"
PrEht" Stands for “PREHEAT”. A product has been selected and the oven is
heating to the programmed temperature.
"
rEAdY” A product has been selected and the oven has preheated to the
programmed temperature. The oven is ready to load a product.
"
COOL" The oven's internal temperature is below what is programmed.
"
Hot" The oven's internal temperature is above what is programmed.
"
ShELF" A product selection has been made after the oven has preheated and the
computer is asking which shelf the product is placed on.
"
hELP" There is a fault in the control system, the computer will not operate until
service is performed.
"
Cont" Stands for “CONTINUOUS”. The oven has been programmed without a
time being entered. The oven will operate continuously at the
programmed temperature.
"
ErrOr" An entry has been made during the programming, which the computer
does not understand.
To Next Page
Loading...
