Lantronix EDS-MD Series - Page 105

5: Commands and Levels
EDS-MD® Wired IoT Device Gateway Command Reference 105
block serial enable
Discards all data coming in from the serial interface
before forwarding it to the connect mode tunnel
(generally used for debugging).
clrscrn
Clears the screen.
connect mode always
Enables the tunneling server to always establish
tunneling connections.
connect mode any character
Enables the tunneling server to establish a tunneling
connection when a character is received on the
corresponding line (serial port).
connect mode disable
Disables connect mode tunneling.
connect mode modem control asserted
Enables the tunneling server to make tunneling
connections when the modem control pin is
asserted.
connect mode modem emulation
Enables modem emulation for connect mode
tunneling.
connect mode start character
Enables connect mode tunneling when the
configured start character is received on the line.
default connect mode
Restores the default connect mode as "disable".
default host mode
Connects to the first host in the list that accepts the
connection.
default local port
Uses a random port number as the local port for
establishing tunneling connections to other devices.
default reconnect time
Restores the default reconnect time value for
connect mode tunneling.
default start character
Defaults the connect mode start character.
email connect <number>
Sets an email profile to use to send an email alert
upon establishing a connect mode tunnel.
<number> = the number of the email profile to use.
email disconnect <number>
Sets an email profile to use to send an email alert
upon closing a connect mode tunnel. <number> =
the number of the email profile to use.
exit
Returns to the tunnel level.
flush serial disable
Characters already in the serial data buffer are
retained upon establishing a connect mode
tunneling connection.
flush serial enable
Flushes the serial data buffer upon establishing a
connect mode tunneling connection.
flush start character disable
Enables forwarding of the connect start character
into the network.
flush start character enable
Disables forwarding of the connect start character
into the network.
host <instance>
Enters the next lower level. Specify the instance for
the next lower level.
host mode sequential
Connects to the first host in the list that accepts the
connection.
host mode simultaneous
Selects simultaneous connections to all hosts on the
host list.
kill connection
Disconnects the active connect mode tunneling
connection or connections.
local port <number>
Sets a specific port for use as the local port.
<number> = the number of the port to use.