Lantronix EDS-MD Series - Page 117

5: Commands and Levels
EDS-MD® Wired IoT Device Gateway Command Reference 117
host <instance>
Enters the next lower level. Specify the instance for
the next lower level.
host mode sequential
Connects to the first host in the list that accepts the
connection.
host mode simultaneous
Selects simultaneous connections to all hosts on the
host list.
kill connection
Disconnects the active connect mode tunneling
connection or connections.
local port <number>
Sets a specific port for use as the local port.
<number> = the number of the port to use.
no email connect
Discontinues sending email alerts upon establishing
a connect mode tunnel.
no email disconnect
Discontinues sending email alerts upon closing a
connect mode tunnel.
promote host <number>
Promotes the identified host, exchanging it place
with the host above it, to adjust the order of the
defined hosts.
reconnect time <milliseconds>
Sets the reconnect time value for tunneling
connections established by the device in
milliseconds. <milliseconds> = timeout in
milliseconds.
show
Displays the current configuration.
show history
Displays the last 20 commands entered during the
current CLI session.
show status
Displays tunnel connect status.
start character <control>
Sets the connect mode start character. The
character may be input as text, control, decimal, or
hex. A control character has the form <control>C. A
decimal value character has the form \99. A hex
value character has the form 0xFF.
write
Stores the current configuration in permanent
memory.
connect (tunnel-connect:2) level commands
block network disable
Forwards (tunnels) network data in connect mode
tunneling.
block network enable
Discards all data coming in from the connect mode
tunnel before forwarding it to the serial interface
(generally used for debugging).
block serial disable
Forwards (tunnels) serial data in connect mode
tunneling.
block serial enable
Discards all data coming in from the serial interface
before forwarding it to the connect mode tunnel
(generally used for debugging).
clrscrn
Clears the screen.
connect mode always
Enables the tunneling server to always establish
tunneling connections.
connect mode any character
Enables the tunneling server to establish a tunneling
connection when a character is received on the
corresponding line (serial port).
connect mode disable
Disables connect mode tunneling.